Radiographic Comparison of Obturation Performed by Conventional Method and Obtura II.
试验速览
- 阶段
- 不适用
- 状态
- 招募中
- 入组人数
- 260
- 试验地点
- 1
- 主要终点
- optimum extension,overextension ,under extension of obturating material
研究概览
简要总结
Root canal therapy plays an importanmt role in dental health care.An importanat parameter necessary to achieve a proper endodontic treatment is quality of root canal filling.This study compare the radiographic quality of obturation with cold lateral condensation and thermoplasticiszed gutta percha technique and obtura II system.
详细描述
The aim of this study is to assess and compare the radiogrphic quality of obturation with thermoplasticized injectable gutta percha technique obtura II system and cold lateral compaction technique in permanent teeth.For this study selected patients will be divided into two groups in a manner that the odd numbers will be alotted to Group A and Group B .Local anesthesia at 2% lidocaineHCl with 1:100000 epinephrine as buccal infiltration in upper teeth and inferior alveolar nerve block in the lower teeth. Access cavity preparation will be done. Canals will be located and negotiated with a DG-16 endodontic explorer . Initial filing will be done from Number 8 to 10 K- files (ISO standardized 0.02 taper) under 5.25% sodium hypochlorite) irrigation and Ethylenediamine Tetra-Acetic Acid as chelating agents.. Working Length will be confirmed with Electronic Apex Locator , and then with working length radiograph will be taken. Rotary preparation will be done with Protaper using S1, S2, F1, F2, F3 files. Master gutta-percha radiograph will be taken at the commencement of the first visit with Protaper F3 gutta-percha point placed in the canals. Intervention will be provided to both groups by the principal investigator. On the second visit, both the canals will be dried with F-3 paper points.Root canal fillings will be then performed using cold lateral condensation in Group A, and thermoplasticized injected gutta-percha in Group B.
Postoperative periapical radiographs will be obtained immediately after the obturation. These radiographs will be examined under illumination in a darkened room at ×2 magnification to assess for voids and termination of obturation. Our study will be based on the radiographic assessment of the buccolingual view of the canals, as it will be the only possible view to visualize on the radiograph in a clinical setting for assessing the quality of endodontic treatment.
Root canal fillings will be assessed
- Presence or absence of voids.
- Acceptable/flush: Root canal filling is within the root canal system and within 2 mm of radiographic apex.
- Under-filled: Root canal filling is >2 mm short of radiographic apex.
- Over-filled: Root canal filling is extruded beyond the radiographic apex
研究设计
- 研究类型
- Interventional
- 分配方式
- Randomized
- 干预模型
- Parallel
- 主要目的
- Treatment
- 盲法
- Single (Outcomes Assessor)
入排标准
- 年龄范围
- 18 Years 至 60 Years（Adult）
- 性别
- All
- 接受健康志愿者
- 是
入选标准
- •Single rooted teeth in which endodontic treatment was clinically indicated.
- •Single rooted teeeth in which root canal treatment was recommended for elective reasons.
排除标准
- •• Teeth with severely curved roots.
- •Sclerosed canals on periapical radiographs.
- •Periodontally compromised teeth.
- •Endodontic retreatment cases.
- •Teeth with apical resorption.
- •Teeth not salvageable by conventional root canal treatment.
研究组 & 干预措施
coventional obturation technique
In conventional method, paper point will be used to coat the walls of the canal with sealer, Standardized Protaper F-3 master gutta-percha cone will slid to the working length and ISO No.25 finger spreader was applied under vertical loading.The first accessory cone will slid promptly to proper length with a light coating of sealer. Compaction and accessory cone insertion will be continued;each spreader insertion will be seen to be slightly less deep than former, as mirrored by shorter and shorter accessory cone insertion. Condensation continued until the spreader reached 2-3 mm into the canal. Heat will be applied with to the root filling at or below canal orifice level, and the filling will then compacted apically with the help of a cold plugger.
干预措施: conventional obturation technique (Procedure)
coventional obturation technique
In conventional method, paper point will be used to coat the walls of the canal with sealer, Standardized Protaper F-3 master gutta-percha cone will slid to the working length and ISO No.25 finger spreader was applied under vertical loading.The first accessory cone will slid promptly to proper length with a light coating of sealer. Compaction and accessory cone insertion will be continued;each spreader insertion will be seen to be slightly less deep than former, as mirrored by shorter and shorter accessory cone insertion. Condensation continued until the spreader reached 2-3 mm into the canal. Heat will be applied with to the root filling at or below canal orifice level, and the filling will then compacted apically with the help of a cold plugger.
干预措施: Obtura II (Device)
Obtura II
The Obtura II system will be prepared ,sealer will be applied to canal wall . A 23G needle is selected and a stopper will place at 4-6 mm of the WL. The control unit of Obtura II will be on, and the display showed the required temperature of 185°C. The gun will be loaded with a fresh pellet of gutta- percha and plunger will be pushed forward.The needle will be then positioned in the canal so that it reached 3 to 5 mm of the apical preparation. 3-4 mm of the gutta-percha was passively injected without any apical pressure and will be compacted gently with a #11 endodontic plugger. Thus, the apical plug will be created in this manner. A segmental technique will be used in which 3 to 4 mm of gutta-percha will be sequentially injected and compacted. Increments will be added until gutta-percha reached top orifice level, and then compaction will be done with a cold plugger. Excess gutta-percha was severed at or below the orifice level.
干预措施: conventional obturation technique (Procedure)
Obtura II
The Obtura II system will be prepared ,sealer will be applied to canal wall . A 23G needle is selected and a stopper will place at 4-6 mm of the WL. The control unit of Obtura II will be on, and the display showed the required temperature of 185°C. The gun will be loaded with a fresh pellet of gutta- percha and plunger will be pushed forward.The needle will be then positioned in the canal so that it reached 3 to 5 mm of the apical preparation. 3-4 mm of the gutta-percha was passively injected without any apical pressure and will be compacted gently with a #11 endodontic plugger. Thus, the apical plug will be created in this manner. A segmental technique will be used in which 3 to 4 mm of gutta-percha will be sequentially injected and compacted. Increments will be added until gutta-percha reached top orifice level, and then compaction will be done with a cold plugger. Excess gutta-percha was severed at or below the orifice level.
干预措施: Obtura II (Device)
结局指标
主要结局
optimum extension,overextension ,under extension of obturating material
时间窗: immediately after the procedure
radiographically observing the extension of obturating material
次要结局
- Density(immediately after the procedure)
- adaptation of Gutta percha(immediately after procedure)
研究者
sheejia asif
Principal investigator
Pakistan Institute of Medical Sciences