Anesthesia in Pediatric Dental Surgery: Effects of a Computer Controlled Delivery System on Pain and Heart Rate. A Randomized Clinical Trial

The sample of this single-blind split mouth study will be made up of 76 consecutive children (38 men and 38 female) between 5 and 12 years attending the Paediatric Dentistry Unit of Catholic University of Sacred Heart, Rome, Italy, from November 2016 for routinary dental treatments who needed at least two dental extractions on both left and right maxillary arches. The participants will have to be in good general health state with no contraindications to local anesthetics. Exclusion criteria are: suffering from any medical condition that could alter pain perception or taking any antibiotic or antinflammatory drugs in the last month before the procedures. A detailed informed written consent form will be signed by each patient's parent or guardian of children enrolled in this study before every clinical procedure. Patients will be informed that a computer controlled and traditional syringe techniques will be used for their dental procedures. No patients should have previously experienced a conventional syringe technique nor the Wand® injection. The sample size was calculated performing a power analysis based on the results of previous studies to detect at least a 1 grade Numerical Visual Rating Scale difference with Standard Deviation of 1.05 and at least a 3 mmHg difference with Standard Deviation of 4 mmHg between groups. The alpha and beta values were set as 0.01 and 0.95 respectively and the sample size was calculated to be 30 subjects for each group.

MEASURES Pain perception will be explained to patients before injections. The Numerical Visual Rating Scale is a pain scale based on Visual rating scale and Numerical rating scale that was used for the same purpose on adults in a previous report. This scale demonstrated to be easier to understand by the patients and was preferred to other scales that could have caused difficulties in evaluation by the children. Heart rate will be assessed using a pulse oximeter before and after the injection.

PROCEDURES One half of the maxilla will be anesthetized using the Wand® system and the contralateral half by a conventional syringe. In both halves the intraligamentary technique will be the sole used. Anesthesia will be administered by the same previously calibrated operator. The order of techniques will be randomly selected. Randomization will be obtained through a random sequence generated by a Personal Computer. A distraction technique for palatal injections, in the form of pressure applied using the handle of the dental mirror, will be used before needle's insertion in both techniques. Following the intraligamentary technique the needle will be inserted parallel to the long axis of the tooth into the sulcus of each root and some drops of the local anesthetic solution will be administered before the needle entered the tissue. After few seconds the needle will be advanced penetrating the tissue and an additional amount of solution will be administered. The Wand® will be set on a pre-programmed injection mode named "Single Tooth Anesthesia" (speed mode 0,005 mL/sec). Once anesthesia will be achieved, tooth extractions will be performed. Patients should have been previously blindfolded with a commonly used sleeping mask so they will not distinguish which anesthetic delivery system was being used. Anesthesia procedures and tooth extractions will be completed in the same session according to a split-mouth design. The Wand® system produces audible beeps that will be deactivated. Immediately after delivery of local anesthetic, children will be asked to remove their mask and rate the pain felt during the anesthetic administration.

All patients will receive mepivacaine 3% with a vasoconstrictor (Carbocaine 20 mg/ml with epinephrine 1:100.000 Dentsply Italy srl). A 1.8 mL anesthetic cartridge will be used for both procedures (Wand® vs. traditional). The local anesthetic will be injected with an extra-short 30 gauge dental needle for both Wand® (30 G handpiece and needle, Milestone Scientific) and with a traditional 30 Gauge needle (Trend Ject 0.30x21mm) for conventional injections.

The following data will be collected through the use of a structured form: