跳至主要内容
临床试验/NCT03227978
NCT03227978Unknown早期 1 期

PCL (Poly-ε-caprolactone) Mesh Pleurodesis in Thoracoscopic Treatment of Primary Spontaneous Pneumothorax

National Taiwan University Hospital0 个研究点目标入组 10 人开始时间: 2017年8月1日最近更新:
适应症
干预措施

试验速览

阶段
早期 1 期
入组人数
10
主要终点
blood pressure and temperature

研究概览

简要总结

Recent advances in thoracoscopic surgery have made it a commonly used technique for treating spontaneous pneumothoraces and preventing recurrence. The goal of surgical treatment is to find the offending bleb, remove it, and do some manipulation to encourage pleural symphysis. Methods of thoracoscopic pleural symphysis have included mechanical abrasion and instillation of chemical irritants. Each method reduces the rate of pneumothorax recurrence to a certain degree, but the recurrence rates after thoracoscopic surgery are widely varied in the literature. Although several articles show significantly lower rates, there are also articles demonstrating that the recurrence rates of pneumothorax after thoracoscopic surgery ranged between 5 and 12%, which are higher than the rates reported after open thoracotomy. It is suggested that a less intense pleural inflammatory reaction is induced by thoracoscopic procedure than by thoracotomy. Besides, post-pleurodesis severe pain and bleeding were encountered frequently. A potential alternative to increase the intensity of pleural inflammation and thereby prevent pneumothorax recurrence is film pleurodesis. Only few studies have been reported where more than one film pleurodesis has been tried, and the mechanism of film pleurodesis remains unclear.

Poly-ε-caprolactone (PCL) is a FDA-approved biomaterial with a slow degradation time of approximately 24 months when degraded by hydrolysis only. Recently, some investigators combined PCL with other biomaterials such as chitosan, polyethylene glycol, hyaluronic acid to produce anti-adhesion barrier for clinical applications. However, only few studies report PCL only could provide anti-adhesion effect. In contrast to common complications of postoperative abdominal adhesions, adhesion (or pleurodesis) is an important therapeutic tool to control the incidence of recurrent pneumothorax. We suppose that if a biomaterial induces adhesion following abdominal surgery, perhaps it may be applied to pleurodesis tool for preventing recurrence of spontaneous pneumothorax. We hypothesized that PCL membrane-induced pleurodesis can be achieved intrapleurally.

详细描述

Primary spontaneous pneumothorax usually occurs in young, lean young men. In most cases, the cause of pneumothorax is rupture of blebs at the apex of the lung. Traditionally, bullectomy with mechanical pleurodesis through thoracotomy is indicated in patients with recurrence or persisted air leakage. The possible causes of recurrent pneumothorax and prolonged air leakage are missed bleb surrounding the endoscopic suture line or suboptimal suturing or healing of the thoracoscopic suture. To prevent these complications, a novel method using coverage of the endoscopic suture line by a large absorbable vicryl mesh during thoracoscopic surgery was proved to be safe and feasible. Theoretically, the mesh can strengthen the suture line and induce local fibrosis surrounding the suture line, and reduce the rate of recurrent pneumothorax and prolonged air leakage. To prove this hypothesis, we will conduct a prospective randomized trial in National Taiwan University Hospital. We will enroll 10 patients with primary spontaneous pneumothorax who will be assigned to PCL mesh pleurodesis after thoracoscopic bullectomy and pleural abrasion. The primary endpoint is to check the biocompatibility of PCL mesh. The secondary endpoint is to evaluate the safety after thoracoscopic bullectomy and pleural abrasion.

研究设计

研究类型
Interventional
分配方式
Na
干预模型
Single Group
主要目的
Treatment
盲法
None

入排标准

年龄范围
18 Years 至 50 Years(Adult)
性别
All
接受健康志愿者

入选标准

  • Primary spontaneous pneumothorax patients who require thoracoscopic bullectomy and pleurodesis

排除标准

  • chronic obstructive pulmonary disease, hemopneumothorax, catamenial pneumothorax, pregnant, malignancy

研究组 & 干预措施

PCL mesh group

Experimental

Intervention: The participants will be received thoracoscopic bullectomy and abrasion of pleura, then PCL mesh will be applied over the lung.

干预措施: PCL mesh pleurodesis (Combination Product)

结局指标

主要结局

blood pressure and temperature

时间窗: three days

mmHg and celsius degree

次要结局

  • pain scale(3 days, 1 month and 6 months)

研究者

申办方类型
Other
责任方
Sponsor

相似试验