Comparison of Different Quadriceps Femoris Isometric Strengthening Methods in Healthy Young Women

Muscle strength, Isokinetic strength measurement:

The dominant side QF isometric muscle strength (torque measurements) of the participants was assessed with the Isokinetic Dynamometer . Before the test, participants were subjected to a standard warm-up of 5 minutes and evaluations were carried out using a standard seat. The back of the seat was angled 105 ° backward to provide 75 ° flexion at the body. The knee was positioned at an angle of 60 ° and was fixed with bands around the body, waist, hip and ankle. Participants had no previous experience with isokinetic dynamometer testing, therefore; it was started with a trial whose protocols were same with QF isometric muscle strength measurement protocols. Then participants QF isometric muscle strength was measured by three 10-second maximal isometric contraction. Rest periods of 3 seconds between each contraction were given. Each participant held the sides of the seat with both hands during the test. Verbal encouragement was made throughout the whole test to obtain maximum strength from the participants. The peak torque and average torques of the participants were recorded after the test.

High Voltage Pulsed Galvanic Current:

The instrument was automatically set to a pulse rate of 100 μs while the pulse frequency was set to 60 pulses / sec. In order to avoid fatigue, the intermittant form of the current was selected and the transition time / rest time was set to 4 sec. impulse / 12 sec. The total output voltage of the device ranged from 0 to 500 volts and the current intensity was increased until the sensible contraction of the applied muscle was achieved without causing too much sense of discomfort. Stimulation was performed after the body and knee were positioned and stabilized at 75 ° flexion and 60 ° flexion angle, respectively. One of the 6 * 8 cm carbonated electrodes was placed in the distal portion of the vastus medialis, while the other one was placed in the proximal portion of the vastus lateralis. This placement was intended to stimulate a large proportion of the muscle fibers of the QF muscle.The HVPG was applied for a total of 20 minutes. Current intensity was increased to obtain optimal muscle contraction.

Russian Current In the treatment with the Russian current, a protocol developed by Kots, also known in the literature as "Russian Technique", was used. In the treatment with the Russian movement, a protocol developed by Kots, also known as "Russian Technique", was used in the literature. There were 10 muscle contractions per treatment session in this protocol. Each contraction lasted for 10 seconds and a resting time of 50 seconds were given for the next contraction (transition: rest ratio was 1/5).The position of the participants in the application and the placement of the electrodes were same as the the other application. Current intensity was increased until tetanic muscle contraction was obtained.