A Prospective Cohort Study Investigating the Success Rate of Fit Testing Following the Use of a 3D Printed Respirator Adapter From a Facial 3D Scan.
试验速览
- 阶段
- 不适用
- 状态
- 撤回
- 试验地点
- 1
- 主要终点
- The success of of fit testing will be measured and reported quantitively using a TSI portacount
研究概览
简要总结
Healthcare workers PPE (personal protective equipment) when interacting with patients either infected or, potentially carrying SARS-CoV-2. One of the major routes of transmission is via droplet spread through oral and nasal mucosa therefore respiratory protective equipment (RPE) is an important part of PPE. There are concerns in dentistry that droplet spread can be increased during aerosol-generating procedures (AGP). This poses an increased risk to dentists and allied professionals in a clinical setting.
Fit testing is needed to ensure a mask forms a facial seal around the mouth and nose. Using a respirator mask without fit testing can reduce its effectiveness from between 6-88% with an optimal facial seal being more critical than the filtering performance. Commercial respirator masks are mass-produced for ' standard' faces, and often fail to provide a good fit for users thereby compromising the intended respirator filtering capability.
Given the high level of fit test failures, without the provision of improved fits of masks, patient care will be highly curtailed for frontline staff at risk of SARS-CoV-2. Therefore, a reusable bespoke 3D printed mask adapter used with a soft FFP3 disposable mask provides an economical solution to address the passing of fit testing.
Barts Health NHS Trust staff members who have previously failed the fit test to the first line FFP3 disposable respirator will be invited to enrol in this study.
Barts/QMUL scan App will be used to capture the facial scan of the subjects using a research allocated smartphone. Participants will be asked to be clean-shaven without any facial jewellery which could hinder the scan data. The App automatically generates a customized 3D print file (.stl) which will be sent for 3D printing.
The mask adapter will be fitted over the first-line FFP3 respirator once it is properly worn and checked as per the procedure.
研究设计
- 研究类型
- Observational
- 观察模型
- Cohort
- 时间视角
- Prospective
入排标准
- 年龄范围
- 18 Years 至 —（Adult, Older Adult）
- 性别
- All
- 接受健康志愿者
- 是
入选标准
- •Subjects who would have previously failed the quantitative fit test on the Trust's first line FFP3 disposable respirator.
- •Subjects willing to use a flexible, disposable FFP3 mask.
- •Subjects should be a minimum of 18 years old.
排除标准
- •Subjects unwilling or unable to give written consent.
- •Subjects who cannot remove their facial hair for religious or other reasons.
结局指标
主要结局
The success of of fit testing will be measured and reported quantitively using a TSI portacount
时间窗: 20 minutes mask fit test
次要结局
未报告次要终点