The Effectiveness of 3D Printed, Low Temperature Thermoplastic, and Prefabricated Orthoses in the Management of Thumb Carpo-metacarpal Osteoarthritis: A Randomized, Controlled Trial.

This study will be prospective, randomized, controlled trial. Patients will be identified for potential inclusion by the surgeons at HULC. The standard of clinical care is for diagnosis of CMC is to perform X-rays of the hand and this is done routinely. Based on these images and clinical evaluation, surgeons will establish a diagnosis of CMC, and provide a grading of severity based on the Eaton/Littler Classification on a referral pad. Eligible participants will then be asked to attend the Clinical Research Laboratory within HULC, where one of the co-investigators listed will present the letter of information and obtain informed consent. Patients who agree to participate will be asked to complete 3 functional outcomes questionnaires (i.e. DASH, PRWHE, and VAS pain scale). Bilateral wrist and thumb range of motion, lateral and tripod pinch strength, and grip strength will also be assessed.

Following the initial assessment, patients will be randomized into one of two groups. Patients will be stratified based on their initial referral by the hand surgeon according to CMC OA severity results to ensure that equal numbers of participants fall into each treatment arm based on the Eaton Classification of their CMC OA. After randomization, patients will attend splinting visit #1 (based on scheduling availability) either the Hand Therapy Department at St. Joseph's Health Care London or Hand Therapy Canada, a private clinic in London. Regardless of group allocation or location of therapy visit, patients will not be charged for their therapy visits or for their splint.

Splinting Visit #1

Group one will be fit with a low temperature custom thermoplastic brace at one of the aforementioned clinic locations and then booked for a follow up appointment in the clinical research laboratory at SJHC two weeks later.

Group two will have their hand placed in a scanner that takes multiple photographs of the hand and reconstructs these photos into a single 3 dimensional computer image. From there, one of the co-investigators (MS) will "draw" the splint, and send to a 3D printer. Patients will come back to a clinic location for fitting, and will then follow up 2 weeks after splint fitting at the clinical research laboratory 2 weeks later.