Effects of Floss Band on Ankle Range of Motion, Balance, and Gait in Chronic Stroke: a Randomized Controlled Study

Ankle range of motion

时间窗: 1 year

Ankle passive ROM was measured using a universal goniometer in a non-weight bearing position. Subjects were prone with the knee joint at 90° . The ankle joint was set at 0° of eversion and inversion. The goniometer axis was placed beneath the lateral malleolus, and the stationary arm was positioned parallel to the fibula. The movable arm was positioned parallel to the fifth metatarsal, with the ankle in a neutral position. The measurement was repeated three times, and the average value was calculated. DF and PF measured angle.

Weight-bearing lunge test

时间窗: 1 year

The WBLT was performed to assess DF in a functional ankle joint. A measuring tape was placed horizontally on the floor perpendicular to a wall. The participants placed their affected-side foot on the tape with their big toe contacting the wall, and were instructed to touch the wall with the knee on the affected side. While maintaining this position, they were instructed to perform lunges by bending their knee, aiming for contact between their knee and the wall while keeping their heel firmly fixed on the floor. Once they were able to maintain knee and heel contact, the affected side foot was moved away from the wall, and they repeated the lunge test. The test was performed with 1-cm increases until knee and heel contact were no longer maintained. The maximum lunge distance was the far-thest distance from the wall to the big toe with the foot staying on the floor (without heel lifting) when the knee touched the wall. WBLT measured distance in centimeters.

Static balance ability

时间窗: 1 year

Static balance was assessed using the APDM Mobility Lab™ Opal inertial sensor system (APDM, Portland, OR, USA). The test was conducted in a quiet treatment room. During the test, participants were barefoot and wore three Opal inertial sensors: one over their clothing at the level of the fifth lumbar vertebra and one on each ankle. Each subject was instructed to maintain their balance as stably as possible in a barefoot standing po-sition (10 cm between heels, toe-out of 5°) for 30 seconds. The test was repeated three times at 30-second intervals. The static balance outcome measure was the postural sway area (cm/s2). The signal was sampled, processed automatically, and streamed to a laptop using Mobility Lab™ software (Mobility Lab, Arlington, VA, USA). Balance measured sway range in millimeters squared.

Gait ability

时间窗: 1 year

The APDM Mobility Lab™ Opal inertial sensor system (APDM) was used to assess gait based on the foot strike (FS) and toe-off (TO) angles. Data were collected from the sensor wirelessly at a sampling rate of 128 Hz and processed to quantify postural sway parameters. The test was conducted in a quiet treatment room. During the test, participants were barefoot and wore three Opal inertial sensors: one over their clothing at the level of the fifth lumbar vertebra and at each ankle. Verbal instructions were given to ensure accuracy. The subject was told to stand still at the start line until the first long tone was heard, at which time they started walking at a comfortable natural pace. When a second tone was heard after 2 minutes, the participants were asked to stop walking. After practicing for 30 seconds to become familiar with the test, participants were asked to walk back and forth along a straight 10-meter corridor at their usual pace for 2 minutes without a walking assist.