Evaluation of Laborpro - a New Device for the Assessment of Progress of Labor

Objective The purpose of the study was to evaluate the accuracy of LaborPro fetal head station, fetal head position, and cervical dilatation measurements as compared to manual/digital examinations and to demonstrate that the LaborPro System is safe.

Methods and Procedures The study population included of women admitted to either Maimonides Medical Center (NY, USA) or Bnai Zion Medical Center (Haifa, Israel) in the active phase of labor, with singleton pregnancy and vertex presentation. One hundred and ten (110) subjects were enrolled in the study. Two subjects were excluded from the study as one from Bnai Zion Medical Center had a system malfunction (PC failure) and one subject from Maimonides Medical Center changed her mind and refused to participate in the study. Sixty Seven (67) subjects (62%) were enrolled at Maimonides Medical Center and forty one (41) subjects (38%) were enrolled at Bnai Zion Medical Center. Subject's mean age was 28.2 years (ranging from 15.8 years to 39.5).

Each subject was examined and in cases in which the first exam (according to blinded physician assessment) was at an early labor stage (cervical dilatation < 3 cm), a second examination interval of at least 2 hours after the first one was recorded. In cases where the first examination was performed at a more advanced labor stages (cervical dilatation > 3 cm), a second examination interval was recorded at least 1 hour after the first one. Each set of examinations (LaborPro and two independent practitioners) of station, position and cervical dilatation was completed within 15 minutes. The two independent physicians were blinded to each other's results and to the LaborPro results. If labor duration enabled further examination, two to three sets of tests were performed for each subject. During labor, the attending physician, a midwife or nurse conducted manual trans-vaginal digital evaluations (TVDEs) according to standard practice with respect to frequency and method.

During the manual TVDE, the clinician used the LaborPro finger sensor so that simultaneous LaborPro measurements of fetal head station finger tip (HSFT) and cervical dilatation (CDFT) were recorded. A trained ultrasonographer (physician, midwife or technician) also performed an ultrasound examination to yield the LaborPro data for measurements of head position (HP) and the head station (HSUS) with respect to BPD vs. Pelvic Inlet or with respect to fetal scalp tip vs. Pelvic Inlet.

Study Endpoints Primary Endpoint The primary efficacy endpoints of the study are average differences between measurements of Head Station (HS) and Cervical Dilatation (CD) made by the device (LaborPro) and by TVDEs.