Clinical Performance of Giomer Preceded by Etching Versus Resin-Based Sealants Applied on Permanent Molars Affected by Molar-Incisor Hypo-mineralization: A Randomized Clinical Trial
试验速览
- 阶段
- 不适用
- 状态
- 尚未招募
- 入组人数
- 56
- 试验地点
- 1
- 主要终点
- Sealant retention: Visual and tactile examination using dental mirror and dental probe using Modified (USPHS).
研究概览
简要总结
The goal of the study is to evaluate the clinical performance of giomer sealant preceded by etching versus resin-based sealants applied on first permanent molars affected by molar incisor hypomineralization (MIH)
The main question it aims to answer is :
Will the use of Giomer (Beautisealant, Shofu, Kyoto, Japan) Preceded by Etching result in similar clinical performance as Resin-Based Sealants(UltraSeal XT™ Plus™ by Ultradent) Applied on Permanent Molars Affected by Molar-Incisor Hypomineralization?
详细描述
Molar Incisor Hypomineralization (MIH) is a developmental defect impacting first permanent molars and incisors, characterized by enamel opacities, and reduced mineral content. This condition can cause aesthetic, functional, psychological, and behavioral problems in children. Moreover, there are dental treatment challenges associated with (MIH)which include behavior management, difficulty with local anesthesia, tooth hypersensitivity, and issues with restoration retention.
Teeth affected by (MIH) are more susceptible to dental caries due to weaker enamel properties and increased sensitivity during brushing. Research indicates that individuals with (MIH) experience higher rates of dental caries and require more frequent treatments. Therefore, it is crucial to implement a comprehensive preventive strategy as soon as lesions are detected on erupting first permanent molars. (MIH) can be categorized by the severity and extent of lesions, with three main degrees: mild, moderate, and severe. The mild form is characterized by opaque white discolorations of the enamel. Moderate cases show more significant discolorations, varying from yellow to brown. In severe cases, there is not only discoloration but also a marked loss of hard tissue, resulting in cavities or enamel fractures.
A systematic review done recommended the use of fissure sealants for mild cases of (MIH) in which first permanent molars do not exhibit posteruptive breakdown (PEB) and highlighted that Resin-based sealants are the most frequently utilized materials for this purpose.
creation of pre-reacted glass ionomer (PRG) filler technology in 1999 , which involves dispersing fluoroaluminosilicate glass particles that have already reacted with polyacrylic acid into resin. Building on this, a new hybrid material known as giomer was introduced, utilizing a bioactive surface pre-reacted glass (S-PRG) filler that merges the benefits of resin composites with those of glass ionomer cements Current evidence suggests that Phosphoric acid etching is the preferred method for sealing pits and fissures as it increases the retention rates. However, more high-quality multicenter randomized controlled trials are needed to explore the relationship between clinical effectiveness, retention rates especially in molars affected by (MIH) sealed by giomer-based fissure sealant preceded by etching using phosphoric acid etchant.
The benefits of this study to the participants:
研究设计
- 研究类型
- Interventional
- 分配方式
- Randomized
- 干预模型
- Parallel
- 主要目的
- Treatment
- 盲法
- Triple (Participant, Care Provider, Outcomes Assessor)
盲法说明
Triple (Participants, Care Provider, Outcome Assessor )
入排标准
- 年龄范围
- 6 Years 至 14 Years（Child）
- 性别
- All
- 接受健康志愿者
- 否
入选标准
- •Healthy children aged 6-14 years who are diagnosed with mild (MIH) according to European Academy of Pediatric Dentistry (EAPD) criteria which includes demarcated enamel opacities (white, creamy, or yellow to brownish), that may induce sensitivity to external stimuli without enamel breakdown.
- •Cooperative children.
- •Presenting at least one first permanent molar (FPMs) that were fully erupted and indicated for non-invasive fissure sealant.
- •Medically fit Children (ASA I).
排除标准
- •Children have hypomineralized (FPMs) with post-eruptive breakdown, cavitated and non-cavitated carious lesions, restorations, or fixed orthodontic appliances.
- •Enamel defects due to a condition other than (MIH).
- •Parents are not willing to join.
- •Molars that cannot be isolated using rubber dam.
- •Uncooperative children.
- •Medically unfit children (other than ASA I).
研究组 & 干预措施
Giomer based sealant applied on Permanent Molars Affected by MIH
- Cleaning with a bristle brush and a non-fluoridated paste will be operated by a slow speed handpiece and absolute isolation (using rubber dam and Young's bow).
- Phosphoric acid etch will be applied to the occlusal fissures for 30 seconds. Teeth will be washed using air-water spray for 30 seconds then drying using air for 15 seconds. Proper etching will be confirmed by a dull frosty-white appearance of the enamel An adequate amount of primer will be dispensed on the enamel surface of the pit and fissure using a brush then will be left undisturbed for 5sec. Gentle air blow for 3 sec and then dryness with stronger stream of air until a thin and uniform bonding layer is obtained.
- The giomer sealant (BeautiSealant, Shofu, Kyoto, Japan) will be applied into the occlusal fissures applied Using the syringe needle tip and a brush into the pits and fissures. Stirring the sealant with the syringe-tip during or after placement will help eliminate any possible bubbles and enhance the fl
干预措施: Giomer pit and fissure sealant with etching applied on Permanent Molars Affected by MIH (Procedure)
Resin based sealant applied on permanent molars affected by MIH
- Cleaning with a bristle brush and a non-fluoridated paste will be operated by a slow speed handpiece and absolute isolation (using rubber dam and Young's bow).
- Phosphoric acid etch will be applied to the occlusal fissures for 30 seconds. Teeth will be washed using air-water spray for 30 seconds then drying using air for 15 seconds. Proper etching will be confirmed by a dull frosty-white appearance of the enamel
- The resin sealant will be applied Using the syringe needle tip and a brush into the pits and fissures. Stirring the sealant with the syringe-tip during or after placement will help eliminate any possible bubbles and enhance the flow into the pit and fissures. Photo - curing for the sealant will be done for 20 seconds using LED light curing unit. The tip of the light will be held as close as possible to the sealant, without actually touching the sealant.
干预措施: Resin based sealant applied on Permanent Molars Affected by MIH (Procedure)
结局指标
主要结局
Sealant retention: Visual and tactile examination using dental mirror and dental probe using Modified (USPHS).
时间窗: at 3 month, at 6 month and at 12 month.
次要结局
- • Marginal adaptation: Using Modified (USPHS) Criteria visual and tactile examination using dental mirror and dental probe (Beste Özgür et al,2022).(at 3 month, at 6 month and at 12 month.)
- • Marginal discoloration: using Modified (USPHS) Criteria visual examination using dental mirror (Beste Özgür et al,2022).(at 3 month, at 6 month and at 12 month.)
- • Surface texture: using Modified (USPHS) Criteria visual and tactile examination using dental mirror and dental probe (Beste Özgür et al,2022).(at 3 month, at 6 month and at 12 month.)
- • Secondary caries: Using Modified (USPHS) Criteria visual and tactile examination using dental mirror and dental probe (Beste Özgür et al,2022).(at 3 month, at 6 month and at 12 month.)
- Anatomic form: Using Modified (USPHS) Criteria Visual and tactile examination using dental mirror and dental probe (Beste Özgür et al,2022).(at 3 month, at 6 month and at12 month.)
研究者
Nayera Mohammed
Principal Investigator
Cairo University