Investigating the Post-Activation Performance Enhancement Effects on Skeletal Muscles Under Varied Loading Conditions

Not Applicable

Completed

• Conditions: Performance Enhancing Product Use
• Interventions: Other: Increasing load strength training; Other: Constant load strength training

• Registration Number: NCT06464120
• Lead Sponsor: Universiti Putra Malaysia

Brief Summary

With the advancement of sports science, Post-Activation Potentiation (PAP) has become a focal point of research, garnering significant attention for its underlying physiological mechanisms. Current studies suggest three primary mechanisms: 1) phosphorylation of myosin regulatory light chains (RLCs); 2) increased recruitment of high-threshold motor units; and 3) a reduction in sarcomere length heterogeneity within muscle fibers due to pre-stimulation (Liu \& Li, 2017). These mechanisms collectively contribute to an effect known as Post-Activation Performance Enhancement (PAPE), which significantly enhances muscle strength and explosiveness shortly after activation (Blazevich \& Babault, 2019).

During the activation process of motor units with increasing loads, low-threshold motor units are recruited first, followed by high-threshold motor units. As the load increases, the root mean square (RMS) value increases linearly, further promoting the overlap of motor unit potentials and the rise in RMS values. This overlap in activation timing among adjacent motor units results in greater overall muscle force output (Liu, 2008; Tian, 2009). The significance of this lies in the fact that as the degree of muscle activation increases, especially under incremental loads, the muscle's ability to adapt to subsequent strength or explosive tasks may be enhanced.

In competitive sports, optimizing the relationship between warm-up and performance is crucial. Research indicates that the duration of PAPE varies with individual differences, training type, intensity, and recovery intervals. The characteristics of the PAPE effect also differ. Additionally, following constant loads, the enhancement and decay rates of performance in PAPE show varying rates at different times, and these rates do not exhibit a symmetrical linear change in absolute value (Liang, M 2020; Guo, W et al. 2018; Liu, R and Li, Q. 2017). The competition pace in sports demands precise modulation of performance enhancement rates after activation, and athletes can leverage these characteristics by selecting appropriate loading forms to trigger PAPE at critical moments in competition. To explore the enhancement or decay rates of performance over different time domains, our research team designed a protocol consisting of incremental loads.

Detailed Description

First, participants underwent a squat 1-RM test using the NSCA testing protocol. The induction exercise was barbell-loaded squats. In the constant load group, the stimulation intensity was set at 90% of the 1-RM, with one set of four repetitions of barbell half-squat jumps . In the incremental load group, the stimulation intensities were set at 5RM, 4RM, 3RM, and 2RM, with one set of one repetition of barbell half-squat jumps for each load intensity. Both the 1-RM test and squat induction exercises were conducted using a Smith machine, and protective personnel were present on both sides. The testing movement involved static half-squat jumps that aimed to enhance the stability of the test and reduce interference from arm swinging. The static half-squat jump required participants to stand with their feet shoulder-width apart on the force plate, hands on hips, and knees flexed to a semi-movement range, and they had to maintain the position for one to two seconds. Following this, participants exerted maximal effort to jump upward (with no visually noticeable downward squatting during takeoff) before naturally descending and maintaining the position for another one to two seconds. Throughout the entire process, both feet were to remain within the force plate area.

Experimental procedure The participants began with a 10-minute slow jog and dynamic lower-limb stretches. As a baseline, the participants' dynamic data for unloaded static half-squat jumps were collected after a 5-minute rest. Following another 5-minute rest, the constant load group underwent one set of four half-squat jump inductions at an intensity of 90% 1-RM. The incremental load group underwent inductions at each load intensity, with one set of barbell half-squat jump exercises for each intensity. The participants received verbal cues and encouragement for each repetition. Dynamic data for static half-squat jumps were collected at 15 seconds, 3 minutes, 6 minutes, 9 minutes, and 12 minutes after the end of each exercise session. At each time point, two valid repetitions were collected, with verbal cues and encouragement provided to the participants for each repetition. Each set of two half-squat jumps did not exceed 10 seconds. The interval between static half-squat jump testing and 1-RM testing was greater than 48 hours .

Study Timeline

• Study First Submitted: 2024-06-12
• Study First Submitted QC: 2024-06-12
• Study First Posted: 2024-06-18
• Status Verified: 2024-07
• Study Start: 2024-07-18
• Primary Completion: 2024-07-20
• Study Completion: 2024-07-25
• Last Update Submitted: 2024-07-26
• Last Update Posted: 2024-07-29

Recruitment & Eligibility

• Status: COMPLETED
• Sex: Male
• Target Recruitment: 14

Inclusion Criteria

(1) Voluntary participation in the research study with prior experience in weighted deep squat exercises; (2) No intake of caffeine within 3 hours before testing and no high-intensity resistance exercises for the lower limbs within the past 24 hours; (3) No lower limb joint injuries (open or closed), no cardiovascular diseases, no skin allergies, and no symptoms of hernia in the last 12 months; (4) Maintenance of regular diet and sleep patterns during the study, and exclusion from any additional strength training activities apart from normal daily life.

Read More

Exclusion Criteria

(1) Individuals with a history of lower limb joint injuries; (2) Individuals with cardiovascular diseases, skin allergies, hernia, or any other contraindications; (3) Individuals unwilling to participate in the experiment.

Read More

Study & Design

• Study Type: INTERVENTIONAL
• Study Design: SEQUENTIAL

Arm && Interventions

Group	Intervention	Description
Incremental load training group	Increasing load strength training	This training plan is a single training，The load intensity of strength training for athletes :（5,4,3）RM×1 time ×1set for half squat jump
Constant load training group	Constant load strength training	This training plan is a single training，This training plan is a single training，Constant load of strength training for athletes :90%1RM×3 time ×1set for half squat jump

Primary Outcome Measures

Name	Time	Method
Height	30 seconds, 3 minutes, 6 minutes, 9 minutes, 12 minutes after intervention and before intervention	The athlete uses a 3D motion capture device to measure the height of the highest point of the half squat jump
Ground reaction force	30 seconds, 3 minutes, 6 minutes, 9 minutes, 12 minutes after intervention and before intervention	The ground reaction force of the lower limbs during the half squat jump was measured by the force platform.
Peak Power	30 seconds, 3 minutes, 6 minutes, 9 minutes, 12 minutes after intervention and before intervention	Athletes measured the peak power of the lower limbs in the half squat jump using a force platform

Trial Locations

Locations (1)

RongWenchao; 🇨🇳 Qinhuangdao, HE BEI, China